Friday, August 30 -- 6:00
Stock Tractor Pull
Pre-35 Tractor Pull
Saturday, August 31 -- 5:00 p.m.
ITPA Sanction Tractor Pull
Sunday, September 1 -- 4:00
ITPA Sanction Tractor Pull
CSTR Stock and Pre-35 Tractor Pull Rules
Pull will be Friday night at 6:00 pm
Registration will begin at 5 pm at the track
Cost: $10 per hook
Driver’s meeting will be held at 5:45 pm
Please direct all questions to Tyler Welborn at 217-377-1496.
Slow Boys Tractor and Engine Club rules (listed below) will be followed unless otherwise specified
Must obey all flagmen on the track
Classes (TRACTOR IS LIMITED TO ONE HOOK PER CLASS)
2 Plow
5250 lb Barnyard
6000 lb Barnyard
7500 lb Barnyard
9000 lb ‘59 and older Barnyard
10500 lb ‘59 and older Barnyard
5 Plow – Turbo chargers allowed 6 mph speed limit
6 Plow - Turbo chargers allowed 6 mph speed limit
Pre-35
Pull will be Friday night at 6:00 pm
Registration will begin at 5 pm at the track
Cost: $10 per hook
Driver’s meeting will be held at 5:45 pm
Please direct all questions to Tyler Welborn at 217-377-1496.
Slow Boys Tractor and Engine Club rules (listed below) will be followed unless otherwise specified
Must obey all flagmen on the track
Classes (TRACTOR IS LIMITED TO ONE HOOK PER CLASS)
2 Plow
5250 lb Barnyard
6000 lb Barnyard
7500 lb Barnyard
9000 lb ‘59 and older Barnyard
10500 lb ‘59 and older Barnyard
5 Plow – Turbo chargers allowed 6 mph speed limit
6 Plow - Turbo chargers allowed 6 mph speed limit
Pre-35
Slow Boys Barnyard Class Rules - 2023
1) Drawbars – All classes except OPEN, will pull from a stock appearing drawbar in a stock mounting location. All drawbars will be measured & checked at weigh-in or certification. The top of the drawbar will not exceed 20” measured from the ground. The minimum distance from the center of the axle to the center of the hitch pin hole will be 18”. Drawbar pull point can be straight or “drop” configuration drawbar.
2) Fast Hitches (IHC) - Fast Hitches (IHC) must be fixed rigid so as to not be able to move when pulling. The top of the hitch will be 20”.
3) Safety Hitches – All classes except OPEN will utilize the event-supplied “safety hitch”
4) Pressed Steel Wheels – will be allowed.
5) Weight Classes – will be 4500 lbs, 5250, 6000, 7500, 9000, 10500, and OPEN. Plow class will also be assigned to each tractor, e.g., an IHC “M” will not be allowed to compete in the 4500 or 5250 class since it’s rated as a 3 plow tractor vs a 2 plow of an IHC “H” 2 plow tractor. The M-M “G” will be considered a 7500, 4 plow tractor.
6) Pull Order – may be altered at the event at the discretion of the promoters or organizers of the event.
7) Engine RPMs – Classes 4500, 5250, & 6000 will produce no more than stock advertized maximum no load rpms. Classes 7500, 9000, & 10500 will be allowed stock plus a maximum of 10% over.
8) Front Weight Brackets – Brackets will be allowed on any tractor, however not “extended pulling brackets”. They may be homemade or factory, however the furthest front edge of the weight or bracket cannot be more than 24” beyond the tractor frame unless they are tractor brand matching factory brackets and weights. Weights do not have to match tractor make. Batteries or tanks will not be allowed on front brackets.
9) Drivers must remain in seat and on the tractor once it is on deck. During the pull the driver must remain seated as manufacturer intended and in a forward-facing position, and able to safely reach all controls. Side saddle seating is not allowed.
10) Tractors will be stock appearing to include hoods, grills, and fuel tanks. Engines must be the proper type for the model of tractor. Crankshaft stroke must be stock and correct for the model of tractor. No stroker cranks allowed.
11) Turbo-charged tractors will NOT be allowed, even if the turbo is removed, except in OPEN class or specific “turbo allowed” classes, if scheduled by event promoter.
12) “Highly modified” pulling tractors will not be allowed at event. If in doubt, ask before travelling.
13) Tires may NOT be mechanically “cut”, however worn tires are acceptable.
14) Tractor models must have been in production prior to 1970.
15) MPH limits may be utilized per discretion of the event promoters or organizers. A speed monitor and horn alerting system will be made available to alert operators & event officials to over speed conditions. Speed operating rules will be announced at the drivers meeting prior to start of event. Speeds per class: 7500, 9000, 10500 = 6 mph, 4500, 5250, 6000 = 3 mph.
16) Minimum driver age will be 16 yrs. Driver must also be able to operate the tractor by themselves.
For any other information,
please contact Tyler Welborn at 217-377-1496.